Model 3 Forged Carbon Fiber Molded Door Handle Caps $139

 
INSTALLATION
Install difficulty: Moderate 2/5
$173.75
  • Description
  • Demo Video
  • Installation Video

100 % REAL DRY MOLDED CARBON FIBER DOOR HANDLE CAPS FOR MODEL 3  Fits all years. (Set of 4).

 

PLEASE WATCH OUR INSTALLATION VIDEO BEFORE ORDERING THESE. YOU MAY HAVE TO ADJUST THE WAY THEY FIT IF THEY RUB ON YOUR DOOR HANDLE EDGE. WE DEMONSTRATE HOW TO DETERMINE THIS BEFORE YOU INSTALL THEM IN OUR VIDEO.

 

SORRY THESE DO NOT FIT MODEL Y. THE POSITION OF THE DOOR HANDLE ASSEMBLY IS NOT CONSISTENTLY POSITIONED INSIDE THE DOORS.

 

Protect you chrome door handles while adding real Carbon Fiber handle caps with our NEW Forged Dry Molded Carbon Fiber Door Handles caps.

Forged Carbon Fiber Composite is a material composed of small pieces of carbon fiber that are pressed into shape as the resin cures. The material is one-third as dense as metal titanium but stronger, and consists of chopped carbon fiber tows that are sandwiched between two layers of filmed resin. Carbon Fiber version is dry molded hand made 100% Carbon fiber. No plastic just real carbon fiber with a glossy deep 3D finish.

These are beautiful caps that fit right over your door handles. Simple to install, just peel and stick. We explain it all in our installation video on the above tab, and check out the DEMO video as well before you order.

Until now we have offered vinyl handle wraps for your door handles, but now you can install these right over your vinyl handles or directly on the chrome stock handles.

 

INSTALLATION TIPS :  First please watch our installation video, and some locations of Model 3 door handles are not assembled exactly the same inside some doors, and sometimes our caps can hang up and not close all the way, or they may rub when you push in the thumb side.

This can be corrected by slightly moving the cap up or down, or right or left. We suggest you try each of the 4 doors WITHOUT removing the red double sided backing tape. Please make sure your door handles open and close all the way before removing the red backing tape and installing these.

With the red tape still on, you simply move the cap around to verify the best location of the cap. You may notice the caps dragging on the top or bottom edge of the door handle hole. If this happens please remember not to install them too high or too low as you will reproduce the problem when you do the real installation.

 

ADJUSTING:  

We have 2 solutions if you install them and notice the handles dragging.

#1. Use a heat gun or hair drying on the handle as this will liquify and soften the double side adhesive. Then you will be able to make minor adjustments by pushing the cap in the opposite direction of where its making contact with your door. Get it real hot for this to work.

# 2 is to again warm up the handle cap and remove it slowly. If the double sided tape remains stuck to the carbon fiber cap just try to reinstall it in a better location to avoid the dragging. If the tape comes off the cap or sticks to your door handle, please let us know so we can send you a new pre-cut inlay of double sided tape.  

 

UV WARRANTY:   Our door handle wraps are coated with 3 coats of UV Protection. Over time without proper care from waxing or applying a nano ceramic coating this protection can be worn off.  

The warranty is limited for only 1 year, and slight yellowing is normal for carbon fiber when parked outside in direct sunlight. To extend the life of your caps we recommend using a detail spray that enhances the UV protection. Also Ceramic coatings will assist with UV protection, and we recommend Ceramic Pro.  

Hello You!

Join our mailing list

.

.

.