Model Y Performance Spoiler - Real Molded Carbon Fiber

Carbon Pattern Warranty: Real Molded Carbon Fiber is hand laid and is not Prepreg Wet Molded, so it may show imperfections in pattern direction. Also, they are made from a two piece mold where the top and the bottom of the spoilers are joined together. As a result spoilers may show a visible seam where the two pieces of mold fuse together. These variations are normal and are not a manufacturer's defect. Please refer to our Return Policy if you would like to return them.

UV Warranty: Our Real Molded Carbon Fiber is coated with 3 coats of UV Protection. Over time without proper care from waxing or applying a nano-ceramic coating, this protection can wear off. The warranty is limited to 1 year. Slight yellowing is normal for carbon fiber when parked outside in direct sunlight and is not covered under our warranty. To extend the life of our Carbon Fiber, we recommend using "303 Protectant”. Ceramic coatings will assist with UV protection and we recommend Ceramic Pro.

Trunk Closing Warranty: If repeated pressure is exerted on the top of the spoiler, like when closing your trunk, the spoiler can crack or split at the fused seam. This is not covered by warranty and is considered wear and tear. We do offer a solution for this, called Tailgate Closing Handle, which will allow you to close your tailgate on your Model 3 or Model S without pressing on your spoiler or your tailgate lid. You can search our Model 3 Tailgate Closing Handle in the search bar above. You do not have to order this item, instead you can close your tailgate as TESLA recommends by pulling down on one of the 2 handles inside the tailgate. Unfortunately it's very hard to close it all of the way, since the handles are on the inside.

Marginal Trunk Warranty: Tesla’s are mass produced and built by robots, as a result there is room for marginality of many of our products, especially our spoilers. Because of this, we ask that you don’t remove our adhesive liner before installing. If you remove the adhesive liner, your order will no longer qualify for return or refund. If you aren’t sure if your TESLA falls under this marginal category and you believe that the spoiler will not fit, we will ask you for multiple images and video evidence. This evidence will help us verify that your trunk was molded differently, therefore the spoiler would not be a good fit. Once we receive the evidence and can verify that the spoiler is not a good fit for your trunk, we will provide you with a free return label. When returning, the spoiler should be in the same condition as when you first received it to qualify for a refund.

NOTE: These are considered USED as soon as the double sided adhesive liner is removed. Used items are NOT RETURNABLE so please be sure you're happy with the way it looks and place it on your TESLA before removing the adhesive liner.

The installation is very easy. Center the spoiler on the tailgate lip, so it will sit flat on the edges. The spoiler is exactly centered when there is 6" of viewable paint showing from each side of the spoiler to the edge of the trunk. Then, clean the contact area where the 3M double-sided tape is applied with rubbing alcohol. Once cleaned, apply the 3M adhesive promoter and let it dry for 30 seconds to ensure a strong bond. Then, peel off the adhesive liner and apply pressure in the correct location suggested in the installation video. After it is installed, we suggest using painters tape to exert more pressure on the double sided tape. 3M says 72 hours is needed for it to fully bond, so please keep this applied pressure during these 3 days.

Local Installation Cost: Free

Check the Description Tab above to watch our SELF installing instructional videos.

Our installation videos provide the necessary information to correctly install our products. Therefore, we strongly recommend that you watch the installation video/s both before ordering and before installing our products.